Labels:text | diagram | sketch | technical drawing | plan | black and white OCR: RP2 RP1 STRUCTURED APPLICATIONS & DESIGNS, INC. COPYRIGHT 1992-1993 THE TWO MEG AGNUS PROJECT U10 A28 4) o O 4) C5 A20 OO O REV 5.00 000000000000000000000 000000000000000000000 000000000000000000000 U3 COMPONENT SIDE VIEW OF BOARD WITH WIRE INSTALLED (2) U7 CLIP LEAD ASSEMBLY, W1 A28 -COMPONET SIDE JP2|DO JP1|DO 4 SOLDER HERE SOLDER SIDE 000000000000000000000 lo C8 CROSS SECTIONAL VIEW OF BOARD WITH WIRE INSTALLED P1 00 .......... U8 FIGURE 1 U95 RP3 TOP VIEW AND CROSS SECTIONAL VIEW OF CLIP LEAD ASSEMBLY INSTALLED IN THE BOARD AT LOCATION A28. TO INSTALL, INSERT THE WIRE INTO THE LARGE HOLE OF THE A20 LOCATION FROM THE SOLDER SIDE OF THE BOARD. THEN 4 INSERT THE TIMNED LEAD OF THAT WIRE INTO THE SMALL HOLE OF THE A20 LOCATION FROM THE COMPONENT SIDE OF THE BOARD. SOLDER THE WIRE TO THE BOARD FROM THE SOLDER SIDE AS SHOWN ABOVE. NOTES: INSTALL THE 84 PIN PLCC PLUG ON THE COMPONENT SIDE OF THE INSERT THE PROGRAMMED PAL 2018 CHIP INTO THE BOARD AT BOARD, BY ALIGNING THE DIAGONAL CORNER OF THE PLUG WITH THE LOCATION U9. MAKE SURE THAT PIN 1 OF THE PAL CHIP IS DIAGONAL CORNER OF THE P1 LOCATION ON THE BOARD. PLACED INTO THE SQUARE PAD OF THE LOCATION. (2) INSTALL THE 84 PIN PLCC SOCKET ON THE COMPONENT SIDE OF THE BOARD, BY ALIGNING THE ARROW AND THE DIAGONAL CORNER OF THE INSERT THE 2 MEG AGNUS CHIP INTO THE 84 PIN PLCC SOCKET SOCKET WITH THE ARROW AND THE DIAGONAL CORNER OF THE U1 AT THE U10 LOCATION ON THE BOARD. MAKE SURE THAT THE LOCATION ON THE BOARD. DIAGONAL CORNERS OF THE SOCKET AND THE CHIP LINE UP. INSTALL ALL THREE RESISTOR PACKS ON THE COMPONENT SIDE OF THE LOCATIONS JP1 AND JP2 ON THE BOARD HAVE NO PARTS FOR INSTALLATION. THE BOARD, BY ALIGNING PIN 1 OF THE PACK WITH THE SQUARE THE THO MEG AGNUS PROJECT PAD OF THE RP1-RP3 LOCATIONS ON THE BOARD. THE BOARDERED PADS BETWEEN LOCATIONS U18 AND A20 HAVE NO INSTALL ALL NINE CAPACITORS ON THE COMPONENT SIDE OF THE PARTS FOR INSTALLATION. BOARD AT THE C1-C9 LOCATIONS ON THE BOARD. DRAWN BY: TITLE: THE THO MEG AGNUS PROJECT PRINTED CIRCUIT BOARD 5 INSTALL THE CLIP LEAD ASSEMBLY AS SHOWN IN FIGURE 1. NEIL COITO ASSEMBLY DIAGRAM DATE: 8-4-92 SHEET OF INSTALL THE 20 PIN 256 X 4 DRAM CHIPS ON THE COMPONENT SIDE SCALE: NONE SIZE: C DRAWING: OF THE BOARD, BY ALIGNING THE PIN 1 LOCATION OF THE CHIPS REVISION: TTMAP50D_ASSEMBLY WITH THE SQUARE PADS OF THE U1-US LOCATIONS ON THE BOARD. 5.80 COPYRIGHT 1992-93 STRUCTURED APPLICATIONS & DESIGNS, INC.
(.png)
